patient monitor module

Patient monitor module.

using Raspberry pi and using customized firmware the monitor device can be build and sent to hospitals

Specifications

  • Microcontroller and wireless connectivity: ESP32, in WROOM32 module format, with a Dual-core Xtensa 32-bit CPU, 4 MB of on-board flash, Wi-Fi, and support for BLE
    • Wireless interface: Wi-Fi and Access Point (AP) modes, a 2.4 GHz radio with an on-board PCB antenna that is compatible with Bluetooth 4.2 and BLE
    • Firmware programming: Supports Arduino IDE as well as Espressif ESP-IDF
  • Sensors:
    • ECG and respiration front end: Texas Instruments (TI) ADS1292R 24-bit analog front end with signal-to-noise ratio (SNR) of 107 dB
    • Pulse oximetry front end: TI AFE4400 pulse oximetry front end with integrated LED driver and 22-bit ADC
    • Temperature sensor: Maxim MAX30205 digital body temperature sensor for monitoring skin temperature
  • Form factor: Raspberry Pi HAT form factor (65 mm X 56 mm)

The Device can be connected to Local area network or star link or even using GSM modem of dongle

the device will connect to VPN immediately and start sharing data with the servers.

if the device fail to connect it will send text message with data on constant intervals to provide feedback

this device will enable the remote doctors to follow patient status on the minute.

Scroll to Top